Vmc VM-3 Bedienungsanleitung PDF herunterladen (Seite 16)

VM-3 • Page 14

Remote Video In

The instruction step numbers correspond

to the numbers in the diagram to the right.

Figure 1

5

Basic Installation of the VM-3

1. Unpack the VM-3 and place it where you

can have easy access to the rear panel.

2. Using one of the Standard (BNC TO

RCA) Cables, connect the BNC end to the

j

ack marked "Video Out Edit." Plug the

RCA end into an edit monitor.

3. Using the other Standard (BNC TO RCA)

Cable, connect the BNC end to the jack

marked "Video." Plug the RCA end into

the television system. In most cases this

cable is plugged into a modulator (using

an RCA to F adaptor) or a display monitor.

If the modulator is farther than 6 feet away,

a custom cable will have to be made by

your installer.

4. If external video is going to be used,

connect another Standard (BNC TO RCA)

Cable to the jack marked "Video In." The

other end of this cable can be connected

to a VCR, Satellite Receiver, Camera, DVD

p

layer or any device that has a video

output jack.

5. Turn the VM-3 so you can access the

front panel. Plug the keyboard in the Din

j

ack marked "Keyboard."

6. Connect the power cord from the

VM-3 to an electrical outlet or

recommended surge protector.

7. Call (203) 358-8842 if you are having

a problem completing these steps.

Character Generator/Video Controller

P

VM-3 Rear Panel

VM-3 Front Panel

Jack to connect the Ke

y

board

Video In

Video In

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

Kommentare zu diesen Handbüchern

Keine Kommentare